Meggaboost has revolutionised the whole concept of cleaning
electrical machinery
ONE
TWO
THREE
It
dissolves oil and grease without damaging insulation or old
varnish.
It's
surface active ingredient physically displaces water which
is then removed by evaporation.
It depolarises and activates carbon deposits, making them easy
to flush out.
New modified Meggaboost has been further improved in three ways:
Its
already very low toxicity has been further reduced and it has
been approved for use in submarines by the
Royal Navys' Institute of Naval Medicine.
It is even more fire
safe with flash point increased to 42°C
Solvent power has been increased by a further 5% These improvements
have been
made without affecting evaporation rate.
Washes out carbon deposits loosened by Meggaboost.
A powerful solvent for oil and grease deposits in its own right.
New Meggawash has even lower toxicity and higher flash point than
before.
Flash Point at 42C.
Fast-coating and high resistivity finishing lacquers. F.P. 37C.
Provide a thorough seal of high chemical and
moisture resistance combined with high surface
resistivity
and anti-tracking properties.
The materials are also anti fungicidial and particularly
suitable for tropical service.
All materials used in Ayrodev Process are compatible with one another
This high-sensitivity meter is an essential part
of the success of Process 1.It identifies the leakage paths causing
the low insulation value and monitors the cleaning action.
This
is important because the apparent overall insulation resistance
is governed by the lowest value path. The 40M gives an overall
reading and identifies the individual critical areas
1
Ensure
maximum ventilation and an air flow over the machine .Operators
should wear filter respirators in a
confined space. While Meggaboost is not, for all practical
purposes, toxic, inhaling the spray in suspension causes oxygen
deprivation.
2
Full
access to the contaminated windings is essential. Remove
all covers and end shields etc.., and split the yoke where
possible. Remove any carbon brushes - Meggaboost will soften
them.
3
Couple on the 40M the 50 voltage range and start to spray.
4
First
carry out a general overall spray with Meggaboost
to soften the deposits. If the machine is
very oily give a preliminary
Meggawash to save Meggaboost.
5
Concentrate on the areas showing most insulation meter reaction
.As each section becomes stable, move to another area. Where
possible, rotate the workpiece from time to time
